Interested to Buy Any Domain ? << Click Here >> for more details...
how to calibrate a control valve?
- 7 Answers
- 63477 Views
- Reliance, Telecon Systems, I also Faced
- E-Mail Answers
Answer Posted / c.grema@yahoo.com
first you have to now your limits if its pneumatic work
from 20 to 100kpa if current i 4 to 20ma
supply pressure,
1.bench set
2.beam alignments
3.calibration
| Is This Answer Correct ? | 30 Yes | 6 No |
Post New Answer View All Answers
Difference between 2-Valve Manifolds, 3-Valve Manifolds and 5-Valve Manifolds 3 with diagram
What are different types of cable?
Explain the difference between mmwc and mmwg?
What types of Instrumentation Related Questions can an Interviewer ask in a Telephonic Interview ?
can you send remote seal interface level transmitter calculation steps for oil water saperator.
What is force balance principle?
Turbidity analyzer working principle ?
Explain PID controller tuning & any one method used for it.
what deference between panel earth and systemearth
How a conductivity sensor & analyzer work at boiler, whats the principle & science is beyond this,How conductivity sensor sence & convert signal & move toward analyzer & analyzer show reading in percent? also what is temperature compensate option in conductivity analyzer
why using negative supply for bentley nevada vibration system ?
What is the purpose of LO Overhead tank in turbines.
what effects a surging can produce in the compressor
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
How to erection of DCS Panel at site step by step
