Interested to Buy Any Domain ? << Click Here >> for more details...
Define Current Transformer?
Working & TYpe's Of C.T.
- 4 Answers
- 7047 Views
- I also Faced
- E-Mail Answers
Answer Posted / kunwar dinesh singh
ct works on the principle of mutual induction. the secondary
winding of CT is connected to the ammeter which is rated at
5 amp. ammeter used to measure load current.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What are the protection required for Transformer, motor, Line, Generator, capacitor, that all i have to refer which standard?(Like Transformer detail IS 2026)
where solid grounding and where grounding through ngr done and why?
Explain with example of functional requirements of protection relay in terms reliability, selectivity, sensitivity
What is the unit of attenuation?
I FINISHED MY B.TECH IN EEE . I AM IN NEED OF A GOOD TRAINING INSTITUTE TO DO COURSES .. CAN ANYONE SUGGEST GOOD CENTRES IN TAMILNADU ,BANGALORE ,OTHER AREAS???????
what is the VA(Volt-amphere)? define with calculation?
In between UPS out going changer over switch and ups raising main input, both side cable gland producing heat but the cable doesn't get heat,Why?
why most of junction box vendors providing T5/T6 Temp class jb's for T3 area any special reason?
What is cathode ray oscilloscope (cro)?
11kv/433v delta/star distribution transformer primary side full load Ht current is 83.33A in , but input side VCB rating 800A.why?
IF TVM OF TRANSFORMER SHOWS POWER FACTOR ON 33 KV SIDE AS 0.97 LAGGING AND ON 132 KV SIDE IS 0.75 LEADING.IS THIS CORRECT.WHERE IS PROBLEM.
bitumar
completed BE & done apprentice at tneb & having experience 6 years. want to get c license. will apprentiship & BE be helpful for getting c license. will i get any preference by showing this?
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
what is relation between ct and pt ratio with multiplication factor of a energy meter? is there any other factor on which multification factor depend?
