Answer Posted / nikhil vaghela
use to measure the pressure at very high accuracy.
Its used in deaerator and furnace pressure measurement.
Where the accuracy is required.
1 kgCM2 = 10000MMWC.
Is This Answer Correct ? | 32 Yes | 5 No |
Post New Answer View All Answers
How to change dcs card in online. (Dsc is maxdna)
how can we tune a PID. If it is by zeiger nichols method..please explain briefly with help of an example.
what is sil (safety integrity level
what is commisioning procedure,2)what is is the main work in commisioning in the field tx to dcs, plz send me detail
can u plz send me technical questions asked in SCHNEIDER ELECTRICAL technical paper?
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
Why plc require in analog input 4-20amp & 0-10 volt?
Type of level transmitter commnly used in Procees area are the following. a.________________This type of level transmitter works as follows
Describe the typical instrumentation used in monitoring the performance of a shell and tube heat exchanger.
where cascade loop use ?
what is Best Among SINK Or SOURCE Type Design In Digital Signal, Either Iput Or Output? WHY?Can any one..
Yokogawa CENTUMVP R6.09 unable to download to Engineering Station with ExaOPC R3.75
The issue is when I try to download the common project section to the Engineering Station (STN) from the HIS in System View, it is unable to connect. The error displayed is:
WARNING: Could not connect to equalize destination. (7001)
Retrying. Number of retries = 0/1
ERROR: LdXopsLoadMain: connect error 10060
ERROR: Processing terminated due to connection error. (7002)
Equalization end with errors. STN0149
---- ERROR = 2 WARNING = 1 ----
Background:
>Updated the ExaOPC software on the STN from 3.60 to 3.75
>STN operating system is Windows Server 2008 R2
>HIS operating system is Windows Server 2016 Stanard
Solutions attempted include:
>Ensuring all IP addresses are correct and all networked devices can be pinged.
>The ability to ping a device using its host name from another device (
Actual using of tube bender to bend 2 opposite 90 deg at correct measurement center to center of tubing.
Which type of pressure can be measured by primary elements?
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?