Interested to Buy Any Domain ? << Click Here >> for more details...
why all selected supply voltages are multiple of
11.i.e440,11 kv,33 kv,66 kv,110 kv etc
- 6 Answers
- 13537 Views
- Suzlon, TCS, I also Faced
- E-Mail Answers
Answer Posted / sakthivel cbe
its due to the form factor... the value of form factor is 1.11
F.F=(RMS voltage)/(avg.volatge)
the voltage in the the line is avg of sine wave we
generating. but we using RMS for our calculation...
therefore
RMS volt= Formfactor*avg voltage
RMS volt=1.11*avg volt...
thats y supply voltage are interms of multiples of 11
| Is This Answer Correct ? | 13 Yes | 1 No |
Post New Answer View All Answers
I HAVE A INCOMING 100A MCCB TPN 25KA, CABLE LENGHT OF 80M 70MM CABLE SIZE FROM MAIN SUBBOARD TO NEW DB.BASE ON THE FAULT LEVEL SETTING OF 45KA.I WOULD LIKE TO FIND OUT 25KA ENOUGH KA. APPRECIATE IF SOMEBODY CAN ASSIST ME WITH FORMULA FOR THIS. FRM: JEFF
What is ideal IR values for ground and neutral.
why is control bus bi-directional?
What is the general power consumption rating of CPU CRT type and Flat type, Monitor,Printer, projector, Scanner?
i have completed deee and i've (June2012-feb 2015 experience in electrical maintenance in pvt ltd company.company having HT & LT electrical power.how to apply electrical C-license ,NOW I was resigned my job,what are requirements of applying for c-license
What will be the output voltage of a transformer if it is primarily energized from a square wave voltage source?
For RCD (Residual current device) Icu is defined. How i can find Ics for them?
10 tube light connect in mcb breaker.one tube light is fault.so breaker is tribe.how fault is rectified.(using 3wire phase,earth,neutral)
If I have 3 essential main switch board and 3 incoming electricity ,but only 1 genset running is that possible.
The ripple frequency in output of fullwave bridge rectifier is a. Half the input b. Twice the input c. Same as input
What is the working principle of MIG welding? and its out put Voltage?
how hazordious area is classified at an oil & gas plant and categorise suitable class of electric equipment in that area like induction motors, LCS, Lighting Fixtures Fluerescent/Flood lights Mercury& sodium lights, J.Bs, Power Cables etc
how to decide no of electrodes for 1600A LT Main incomer panel
When can we take Neutral as common neutral link?
What do you understand by oldham's coupling ?
