Answer Posted / antaratara ghosh
It is the impedance of the secondary circuit in ohms and
power factor..the burden is generally expressed as the
apparent power in volt-amps absorbed at a specific power
factor and at the secondary rated current...
Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
Why does the speed regulating system adopting I controller have no steady-state error? In this single closed-loop speed regulating system, when the input of the I controller Un=0, what is the output voltage of the regulator? What factors do the output voltage depend on?
What is the maximum No. of out going mccbs permitted from an LV distribution paqnel? What is the ampere relation between incomer and out going switch gears/mccbs?
how to erect roof control panel?
why and how voltage sharing in transformer, during magnetic balance test ?
What is meant by system?
what is PID control in VFD drives?
what is the criteria for selection of conductor used for ehv ac electrical dischrge
List some examples of renewable energy?
why the active power flow of some line is increased when the active power of out is cut ?
What is the Basic Difference bitween Long Shunt Connection and Short Shunt Connection in DC Generator?
what is class of SPD and dittels of all class ?
What is relation between transmission lines & Communication lines ?
How can we connect additional batteries to three phase ups? What are parameters we have to check when connecting?
1.dg on load alarm/stop alarm... 2.dg on load. piu alarm alarm kaise chek krte hai
The electromagnetic torque developed is proportional to what in a D.C series motor?