IF we have 500kva transformer 11.0/0.415V, 50Hz. How to
calculate the current on HT & LT side, how can we consider
for its breaker (HT & LT both)? You are requested to solve
the question herewith.
- 3 Answers
- 13443 Views
- Bhutan Power Corporation, I also Faced
- E-Mail Answers
Answer Posted / sagir
Thanks for answer of this question.
Can you also clarify, on LV side you have multiplied the current with 1.2, why is this??
Also clarify we usually take 3Cx240 & 3Cx300 sqmm Al. cable from HV side. What is the calculation for this cable??
| Is This Answer Correct ? | 6 Yes | 3 No |
Post New Answer View All Answers
Sir, I m 3rd year student 4m DCE and want to do internship in siemens or l&t or any other mnc related to electrical engineering. please tell me the procedure 4 same and oblige me
Is there any problem about which the drive (inverter) doesn't show/display the alarm and/or fault but instead of this , it doesn't work ? I want to know that could there be any kind of problem in the drive when the drive doesn't display the alarm and/or fault ?
Is vtg is controlled by the resistor? if else how much?
in dc series motor if field wdg is shorted then
What are the transformer losses?
why and how current drawn by battery charger depends upon the altitude where it is located?
What is the difference between solid grounding and impedance grounding?
why the earth is taken minimum in supplying? wather it the proportional factor to getting work any equipment or a power plant?
Is it true online ups having bypass mode if it is true then why we called ups because it is interrupting power when goes in bypass mode
What is the function of the circuit breaker failure relay?
In siemens S7-300 PLC, what is function and function block ? What is the difference between them ? When to use function and when to use function block ?
please send me latest & previous years question papers for IOCL Technical level questions
What is the difference between hot and cold loop testing?
what is allowable ac mixing in dc
how the synchronizing is obtained at bus couplers in grid substation? (because there we cannot change the frequency in one of transmission lines like in generator synchronization)
