Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / r.g.m
first we must check the connections through the scheme
diagram,then trace out the open and closed limit
switches.verifiy the connections between open and closed
limits...........
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
line up procedure for dp type flow transmitter?
What is force balance principle? State some of its’ advantages.
In Safe Guarding test what means by "Failed to Danger" ?
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
what will the sending unit in the fuel gauge utilizes?
In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?
what is temperature compensation?
what is difference between fork type and capacitance type level switch. where it is using
Difference between dcs and plc including date processing and architecture.
What is difference between Ionization heat and bimetallic heat
Why ac supply load cell is used? Can we use the dc supply load cell?
what is a half wave, full wave, and bridge rectifer.
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
Specify ideal accuracy of flow element like orifice plate, Ventury, Annubar. Ultrasonic flow meter etc.
WHAT IS THE DIFF. BETWEEN SKIN TEMPERATURE AND PASSES TEMPERATURE..?
