how the lap length is calculated in reinforcement of 110mm
dia steel of Length 15.00 mtrs. & grade of concrete is M20
Answer Posted / mithosh g nair
if dia is 110 mm then that bar must be welded. bars below 32mm dia
the lap length
In tension 50* dia
In compression 45 * dia
Is This Answer Correct ? | 34 Yes | 4 No |
Post New Answer View All Answers
material required for construction of 1cu.mtr wall (Cement, No of bricks (Brick size 40cm x 20cm x 10cm),sand,Quantity of water
In few lines, please be elaborative on extras and talents that make you a potential candidate for the post:
how to caliculate required amount of cement and sand required for 1cu.m.
How to test cement,sand,20mmbluemetal,40mmbluemetal,bricks,concrete by visual and instrument
Dear Engineers, Can you please advise me the material requirement to construct a room 4 M x 4 M 1. No. of Standard Brick 2. Requirement of Cement Bags 3. And Concrete for Steel, Cement, sand, etc Thanks
What is the use of offset command?
how to caluclate sienerge qty in construction in ap
What is the standard rate of installing ties for column(60cmx60cm) and beams(50x850)(weight)
Define What is the difference between routing maintenance and major maintenance in school facilities?
What is the worlds largest concrete dam?
In reclamation works what are the importance of geotextiles and sand?
how to read the drawings to find the quantity of steel in a storm water manhole or any other structure?
I have certain queries, please help to solve. a) length of pile bore is 4m.excavation quantity will be area * length where area will be pi/4 * dia*dia. Is this right? b) It is a single reamed pile of 300m dia and reamed dia is 750mm. can any body help me to calculate excavated quantity of this bulb(reamed section),, concrete quantity in bulb with showing the formulas to be used?
What are the Types Of DPC and its Thickness used?
List out some of the software used in the construction sector to estimate cost and monitoring expenses?