Interested to Buy Any Domain ? << Click Here >> for more details...
What is the diffence between prescribed mix and design mix
- 3 Answers
- 29032 Views
- DPI, L&T, I also Faced
- E-Mail Answers
Answer Posted / eng. mohd noor salleh
Designed mix for which plant/producer is responsible for
selecting the mix proportions to produce required strength
or performance whilst the prescribed mixes for which the
proportions have to be in accordance with the quantities
specified in BS or specification. The producer/plant is
responsible for ensuring that these proportions will produce
a concrete with the performance/strength he requires.
| Is This Answer Correct ? | 11 Yes | 5 No |
Post New Answer View All Answers
what should be RCC material i.e iron rod(mm)x cement x stone x sand for laying of slab L 42'x B 22'x tk 0.375ft = 1nos & column of H 17'x15"x8" 2nos.
give me the rate analysis for Bituminous Macadam and SDBC
how much repeitation for conventional and maivan formwork?
what is the percentage of silt in black cotton soil.?
What are the ingredients of pre-stressed concrete?
How are freeway bridges built?
Different sizes of Hollow blocks and its weight. Thanks.
How much cement will require for 1Rmt Skirting laying
Which brick is best for construction ,either fly ash or AAC BLOCKS
How can calculate the requirement of steel bars of rcc slab for 1100 sq ft?
How much does the leaning tower of pisa lean?
how to find the cement bags and sand requirements for the one square meter of internal,external,ceiling plastering by using the various ratios like 1:3,1:4,1:5,1:6
How to calculate the cement consumption in RR Masonry in CM 1:8 for the foundation of Ground Level Reservoir
Design a reinforced concrete combined footing (rectangular) for two columns located 3.60 metres apart. The overall sizes of the columns are 40cm x 40cm and 69cm x 60cm and the loads on them are 1000 kn and 1500 kn respectively. The space available for the width of the footing is restricted to 180cm. The S.B.C. of the soil is 280 kn/mm2 use M15 concrete.
States some of the commonly used commands in cad software’s?
