Generally In transformer Tap Changer on HT side, but I have
seen in 66KV side in 220/66 KV, 100 MVA, Areva make
transformer. Why ?
- 7 Answers
- 9460 Views
- I also Faced
- E-Mail Answers
Answer Posted / prodip kr. paul
The purpose of OLTC is to regulate the output voltage
constant as per rating plate, but the incomer supply
voltage is variable in kind, so as per incoming supply
voltage the winding turns are selected according to voltage
per turn designed by maker and as per available incoming
voltage incoming side of transformer winding turns are
selected, means OLTC fitted in primary side, it may be LV
or HV side.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
how we find transformer capacity by ohm
how many stairs have you climbed while you were coming
what is the difference between surge protection capacitor and surge arrestor
What are the advantages & disadvantages of a group electrive drive?
How much dc volt applied in cathodic protection system?
why we use single core 630mm2 cable for transformer secondary side
Difference between low impedance and high impedance Restricted Earth Fault
and gate circuit diagram,amplifier circuit diagram
What Normal(Tangent) towers and Tension(Cut-point) Towers?
What is meant by sag?
what is the differance between HT motors And LT MOTORS.
The 3 phase 400 hp 440 volt slip ring induction motor do not take one phase amps why ? The motor is running good condition
the typical output of a solar cell is........
What is meant by a stray loss of a induction motor??? What is the equation to find it
if you are in a software company,then why do you want to come in a core company like sail, ntpc(where lots of trouble like tension but you have a good life in a it company) ?
