Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between HV and LV Breakers?
- 4 Answers
- 12905 Views
- GM General Motors, OEG, I also Faced
- E-Mail Answers
Answer Posted / shri..
1) HV is used for High Voltage lines & LV is used for Low
voltage line.
2) HV breakers have high voltage & low current carry
capacity & LV breakers have low voltage & high current
carru capacity.
3) HV breakers size will be bigger than LV breakers.
4) HV breakers poles gap will be higher than LV.
| Is This Answer Correct ? | 19 Yes | 2 No |
Post New Answer View All Answers
how to test the turn ratio of 3 phase transformer using volt meter shoe the curcit diagram.
How can find thermal state value in relay for calculate thermal overload.
What are gain margin and phase margin?
How to minimize the eddy current losses?
what is the difference between active power and reactive power and apparant power in practical as well as theoritical
how to avoid electrical shock how capacitor store charges wat are the speed control of induction motors state faradays law flemings left hand rule what is rotary converter wat is transmission and distribution what are the sources of energy abrevation of acb,vcb,sf6,igbt what is output equation of transformer which test copper iron and iron loss are calculated what is eddy current draw a single line diagram (10 marks) draw direct online starter(10 marks)
1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?
Single line diagram for dbb (double bus bar)system.
What descriptive information does the NEC require to be marked on all conductors?
State nyquist stability criterion.
When lag/lead/lag-lead compensation is employed?
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING) I O (current operating)?
What is non-minimum phase transfer function?
solar inverters was not connected to the nuteral link .this nutwral possible to any other systems
difine electrical ballast in HPSVL
