Interested to Buy Any Domain ? << Click Here >> for more details...
purpose of breaker contact multiplication relay?
- 5 Answers
- 25725 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / rajesh
the purpose of breaker contact multiplication relay is to
get NO & NC contacts, which can be used for breaker on and
off indication in remote places.
| Is This Answer Correct ? | 9 Yes | 2 No |
Post New Answer View All Answers
what is the voltage regulation for unity and zero power factor?
How to design harmonic filter at the project stage without nowing the harmonics levels
how to electronic energy metter failed in electomagnectic fild passing in the metter and which thing to defect more on metter.
why we use 630mm single core cable for transformer secondary side and why two neutral cable
what is the function of statics switch in ups and tell me parts
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
critically criticize the application of ring main unit in power system
Explain few advantages of electric traction system?
What will happen if i used 11KV earth ht kit to 11 KV / 11 KV cable termination?
Assuming that a dedicated neutral earthing transformer is provided for each GT generator, when the two generators are running in parallel, has consideration been given that the earth fault current from one generator stator winding be split between the two neutral earthing transformers? If so, what adverse impact will this have on the operation of the 59N and 27TN devices?
How to use computer cpu ups use for home inverter circuit board
what is servo motor & how does it work.
If I want to replace a 26KW Slip ring Motor with a Squirrel Cage motor & Drive (for a Hoist Application). How can I approximate the Motor & Drive HP required in new Setup.
PLZ sent the previous year question paper for GET in NHPC on my EMail id ppshanker@gmail.com
in Contactor opearation Why there is a difference in the values of the operate and release voltage in case AC supply
