Interested to Buy Any Domain ? << Click Here >> for more details...
What is maximum permissible length of cable from transformer
(33kV/0.433kV) HT side to HT panel which contain VCB? In
which standard i shall get this information.
- 6 Answers
- 16298 Views
- MSEB, I also Faced
- E-Mail Answers
Answer Posted / satyajitt_1983
Before calculating the Cable length we have to decided the
cable size which is depend upon the terminal size of
Transformer & HT panel. After selection of cable size & no
of run we have to calculate the voltage drop which should
be within the limit of the specified project.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
how to calulate short circuit current for the following: 1.cable connecting 11KV of 22KV/11KV transformer to 11Kv of 11KV/415V transformer 2.what cable size should i use.
How do I calculate a WTI CT ofa 1250kVA 6600/400V transformer
Why increase in current leads to increase in conductor temperature?
how to find impedance , mutual indatnce in transmission lines
How much pf maintan in dg set in 6o% load,when Dg runnig Neutaal Earthing removed what happen.
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
which fault is severe and why?between lll fault and lllg fault which fault is severe and y?
What will happen if we on 200kvr capacitor bank(11kv in bus)If there is low load on transformer (1.5 mva 33/11 kv)
What is d main advantage of using double circuit 3 phase transmission ?
for compensate 315mh inductance ,how many capaciance required?
What is corkscrew rule?
what is meant by brushed alternator & its working principle ?
How would you relate your key competencies to this position?
I WANT TO know WHICH WAY IS BETTER FOR CONNECTION BETWEEN POWER TRANSFORMER AND MAIN DISTRIBUTION PANEL. 1-IS BETTER WE USE CABLE? 2-IS BETTER WE USE BUS DUCT? my transformer rate power is 2500KVA
Scott connection is used for A 3-phase to 2-phase conversion B to achieve higher effciency C to save copper D to reduce harmonics
