Interested to Buy Any Domain ? << Click Here >> for more details...
What is maximum permissible length of cable from transformer
(33kV/0.433kV) HT side to HT panel which contain VCB? In
which standard i shall get this information.
- 6 Answers
- 16310 Views
- MSEB, I also Faced
- E-Mail Answers
Answer Posted / pravin
if a long cable is connected what will happen to charging
current & surges that may affect transformer winding. Also
the protection given to transformer is overcurrent & earth
fault that may not work properly, it may mal operate. I am
surching for any standrad that could specificaly mention
this matter.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
What Is Sampling?
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
How to resolve if Diesel generator stop while running ?
how make megger test for control cable like 12c x 1.5mm and what it apply voltage and test timing details.
WTA used cb?
What is the difference between earthing,ground&nutral?
what is the purpose of silicon dropper used in battery charger?
I have a 380 KVA DG set. How can i find out 1. My Fuel Consumption per hr ? 2. Electricity produced in 1 Hr. ? 3. If load varies then how does it affect fuel consumption & electricity produced ? Please HELP !!! Really need an answer.
is that any software calculator to calculate the size of cable
What is the rotor frequency of 10 Hp 1440 RPM 50HZ 415V ?
What is the disadvantage in proportional controller?
How can we increase the capacity of Energy.?
How do i perform grounding of star point of Genset (400V) for making connection with step up transformer of DELTA-DELTA (400V to 20KV) ? while Genset itself has its own neutral and grounding bus bar inside genset breaker box whereas we have another neutral and grounding busbar in synchronizing panel next to genset at maximum distance of 6meter, would someone pls advice if we can only perform neutral grounding in synchronizing panel or should we ground neutral on both places inside genset breaker box and synchronizing panel.
What is difference between Sample test and Routine test in safety standard?
What is the general system requirement of alternator?
