how to caculate cutting lenght in bar bending schedule for
180 degree bend
Answer Posted / vishal
for 90degree is 2d for 180 degree how much is cutting length
please answer from vishal
Is This Answer Correct ? | 14 Yes | 5 No |
Post New Answer View All Answers
What is the material consumption- cement,sand,tiles etc for Toilet dado?
What is the maximum strength of cub compress strength in one cub testing
is basic cost of the material includes tax?
In block work seawalls what is the purpose of slip joints?
what is pouring and explain
List out some of the checking’s, done at the completion of construction?
what is the breaking strength of wall tiles
What is Architect-Prepared Contract?
i) Distinguish between Theodolite and dumpy Level? (Marks-8) ii)Distinguish between Viscous and Turbulent flow? (Marks-8) iii) Distinguish between nominal and design mix? iv) What is standard sand? v) Explain the term plane stress? Vi) Differentiate between principal plane and principal axis? Vii) write short notes on Elastic limit of structural steel? viii) Write short notes on stress concentration? ix) write short notes on "Grading of Sand" ? x) How many grades of concrete are there under standard concrete?
What is an ice dam sock?
With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr
what is Quantity of stone and sand required for one cubic meter of stone work (UCR)
How much wastages taken in 1. cement 2. steel 3. fine aggregate 4. coarse aggregates (10mm, 20 mm)
What is the use of extruded feature in solidsworks?
How to find CN by using arcgis 9.3?