Interested to Buy Any Domain ? << Click Here >> for more details...
a 650 KVA diesel generator is 1500 rpm, voltage is 415V n full load amps is 805 something,when are applied load more than 400 amps it's voltage is dropping, what is the reasons...?
- 4 Answers
- 8044 Views
- I also Faced
- E-Mail Answers
Answer Posted / sanjay
There can be one of the following reason for the problem :
1.The AVR may be faulty.
2.The conductor is of lesser current rating.
3.Loose connection/faulty cable termination
4.Load is quiet far off from generator.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
What are the main advantages of generalized error co-efficients?
what is earthing transformer? draw the winding dia.of earthing transformer.
What is gross error?
what is the significance of cabability curve of alternator
Why in 6 KV XLPE cable termination kit used and why not in 380 V xlpe cable same is not used
Why are cables rated for 40 KA for 0.25 Sec fault current rating?
what is accuracy ? in any meters , coils accuracy . how can u defined that ?
what is the electrical?
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.
Why is it prefer to initiate circuit breaker failure by "86" lockout relay not by "94" tripping relay ?!
while doing high potential for 11KV 3 core cable how much leakage current will obtain?, what will be acceptance value?
what is diff btw electric,magnetic & eletromagnetic field
how to decide choke rating for drive?
how to calculate the lightning arrester conductor @ no of earth pits required
What is the most essential condition for the voltage build up for a d.c. Shunt generator?
