Interested to Buy Any Domain ? << Click Here >> for more details...
what happen when unit step signal is applied to a
integrater circuit.explain with graph
- 10 Answers
- 17595 Views
- BARC, I also Faced
- E-Mail Answers
Answer Posted / saidesh kumar
when we integrate a constant w.r.t a variable we get the
same variable as output. so unit step integration gives ramp
as the output.Integrator is simply a low pass filter.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
A thread has to access the address space of all other threads in the same process and can therefore mess up the stacks of other threads. Why is this not a protection problem? Could the same be allowed to occur for processes, e.g. one process writing data into the stack of other.
explain about IEEE 802.11 wireless home networking?
What is the difference between CAT 5e communication cable & CAT4 Communication cable
What are the two types of trc?
Write two characteristics of combinational circuits.
We have 6.6 KV, 250 KW HT Motor and i want to run this motor with 250 KW LT Variable frequency drive. Is this Possible? How? what are the major modification required?
Hi Friends, I am preparing for Airport authority of India ,so please forward me question papers and questions that are generally asked in test. my email ID is :jitinkumar_micro@rediffmail.com
why e1 capacity 2048 define details?
What is meant by k-map or karnaugh map?
"11101111" when that bit oriented message transmitting from sender to receiver.how is it calculate parity bit and how is it show bit stream that would be transmitted..by even parity error detection scheme..pls send me an answer..very important,,
pls send my id for supervisor model paper qustion
How the FM 200 System is work? Just give me a reply about the Fire Incident and then Suppression by FM 200 step by step? Regards, ZahIR Uddin Babar For, BAFFESCO
Which type of power plant is more easier to produce electrical power at economical condition?
explain with a suitable diagram how a vidicon pick-up tube is employed in a monochrome TV camera to develop luminance signal
Why r-c filters are suitable only for light loads?
