Interested to Buy Any Domain ? << Click Here >> for more details...
can any one tell me the formula to select the thickness of
wire selection according to ampere rating
- 2 Answers
- 4590 Views
- I also Faced
- E-Mail Answers
Answer Posted / mahesh babu calicut
A log book is available for ch6osing cables at different conditions for different load currents.any how we have to consider voltage drop also in the case of long distance cables(maximtm allowable v.d from mdb to final destination is 5%) if it exceed the limit choose the next higher size. (voltage drop/amps/km for all size of cables available in log book
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
what happend to DC shunt motor if its field winding insulation becomes slightly weak? will that motor can run on full load or not explain in detail. thanks
how to compute kAIC? with formulas...
how to handle 2500 kva transformar
can i connect the two phases of scott connected transformer,if not why?
how oil in the MOCB was reduced compared with OCB? what are the features of the MOCB?
What is cross over distortion? How it can be eliminated?
What is the RME and explain the full form and what is the RME work?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
what is a types of short circuit and what is a types of distance protection tests
why occ characteristics curve in not tracing back when we are bringing back the rhoestat?
What is the automatic voltage regulator with servomotor?
what is the requirement regarding earthing of Single conductor with AWA
model question paper for supervisor trainee
what is difference between window type and wound type transformers?where we will use window type and wound type transformers?
1.25 kg of hydrogen are burnt with stiochiometric air, the mass of air in kg required is
