Interested to Buy Any Domain ? << Click Here >> for more details...
if you short the any 2phase(R,Y,B),why fuse get blown?
- 5 Answers
- 10763 Views
- Steel Plant, I also Faced
- E-Mail Answers
Answer Posted / shakir
when we short two phases the resistance between them is 0 and
current goes to infinity (I=V/R). such an infinite current
when pass through a fuse,the fuse gets blown.
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
what are the basic insulation levels & what its Unit
What is Auto Mains Failure Panel & Auto Synchronizing Panel
What is an 86-P or an 86-A trip
What are test signals and their significance?
What is highest size of HT motor like 11 kv or 33 kv,and how to make it 750 rpm.i think the size will be very big.any idea ? pl. reply..
What is marx circuit?
Why does increasing the magnetic flux in the main field of a d.c motor cause the armature current to reduce??
show the single line diagram of star delta starter with single phase preventer
how can we say that stator magnetic field rotates with synchronous speed?can we derive?
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
Can you used moeller lzm1 mccb in a dc system with 125vdc and 20ka short circuit current , beside is it have 24 or 48 volt shunt ? Beside how long current can through from An MCB shunt contacts? (like Z7-AS 24 V)?
take 100kva DTR( delta/wye ), what ll happen if we connect 11kv to LT side instead of connecting to HT side? will the DTR behave as a step up transformer or something else????
How much load can take a 16 mm aluminum cable 3 phase
What should be the length of transmission line so that we can see/obtain the full sine wave of voltage??
Define stepper motor. What is the use of stepper motor?
