what is the effect of power factor in electrical circuit ?
if we mainten power factor near about unity (0.999) our
energy consumption Units increase or decrease?
Answer Posted / chandra sekhar
if power factor lagging then losses will increase, then more
units will consumption.pf should not in leading position.so
to reduce that losses we ll maintain pf close to unity....if
pf is 1 then we ll get kva=kw....reading...THEN UNITS WILL
GET REDUCE,....
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
ANY ONE TELL ME ABOUT generator synchronization panel panel to synchronise 3 gen of 250kva both automatic and manual. 2 gen output vol 415 3ph, 1 gen output vol 400 3ph SEND THE DETAILS DIAGRAM ON THIS EMAIL ADDRESS ayazleo@hotmail.com as soon as possilble best ragrds electrical engineer ayaz mahmood SAUDI TECH
how the B-H loop obtain under the static condition
what is high - pot test. what's its use?????
what is sevice settings for mccb?How can be it setted?
What is the meaning of 40X8X2 busbar dimensions for carring load of 400 Amps
How to select the earthing transformer,for DELTA TO DELTA TRANSFORMER OR ALTERNATOR SIDE.Pls post your answers and calculation.
lorteny method
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
(1)WHAT HAPPENS WHEN SUDDENLY LOAD GIVEN TO THE INDUCTION MOTOR ? (2)CAN WE MAKE WOOD AS MAGNET ? (3)WHAT IS THE VALUE OF MAGNETIC FLUX DENSITY IN TRANSFORMER ? (4)WHY WE ARE USING ELECTROMAGNETI NOT ELECTROSTATIC IN MACHINE ?
please tell me when we start motor without load in star or delta connection whose current above condition,pl write formula
What are the causes for the failures of sandwich type (Al) busducts?
Which Class insulation is prefered for the sandwich Busducts ? Why?
Why front mounted CT polarities are always towards breaker?
how we find transformer capacity by ohm
in an electronic tri vector meter when the current and voltage sequence changes ? what is the effect of phase sequence on recording of meter