how to check the earth resistance value& what is the
minimum earth resistance for good earthing sysytem.
- 33 Answers
- 144739 Views
- Brookfield, BSNL, DMRC, Epoch, KPTCL, Polycab, Power Control, SIEA, Siemens, Wipro, I also Faced
- E-Mail Answers
Answer Posted / guru
There is not one standard ground resistance
threshold that is recognized by all agencies.
However, the NFPA and IEEE have recommended
a ground resistance value of 5.0 ohms
or less
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
i want to know that what is the eligibility critaria for ongc exam?
I want to ask that is there any relation between current denesity of copper and material purity. also is ther any standard which defines the standard current denesity of material.
WANTCONTACT NUMBER & EMAIL/ WEBSITE TO CONTACT THE SECRETARY,MADHYA PRADESH LICENSING BOARD(ELECTRICAL),K- BLOCK,3RD FLOOR,SATPOODA BHAWAN,BHOPAL
What the difference between three phase contactor (coil 110vac) & three phase SSR (control voltage 110Vac)? May I use contactor in place of SSR?
What are the criteria shall be considers for sizing Fuse and MCB? If the rated current is 10Amps what should be the fuse size / MCB Size?
how i calculate the syncrones generator NGR resistance .if we have a 6mw generator line voltage of generator 11kv also line current 393.3 ampere.
Dear Respected sir how to test ABB REX521 protection relay by relay tester.
IF 8255 CONTROL WORD IS 94H,Tell the chip port work mode ?
What is the difference between amorphous core transformer and CRGO core transformer?.
What is the basic of DTH.
how to calculate transformer turn primary & secondary side 11kv to 420v
What is dielectric loss?
what is the disadvantages of common earthing for AC and DC equipment? (i am talking about inverter control room and inverter duty transformer earthing is common...?)
How to calculate the Efficiency of Chiller
why in the three pin plug all 3 pins are cutted ?
