Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / keshava prakash
Contract demand is the demand(load in terms of KVA/MVA)
based on the customer requirement with power supplier as
per the supply agreement. Maximum demand is the maximum
load recorded during the billing cycle (usually a month)as
per the power supplier. Billing demand is the demand
charges billed by the supplier based on maximum demand
recorded and contract demand. It varies depending on the
power supplier. For example in Karnataka state all
Electricity Supply Company under Karnataka Power
Transmission Corporation, bills based on 75% of the
contract demand or maximum demand recorded whichever is
higher in a month.
| Is This Answer Correct ? | 38 Yes | 1 No |
Post New Answer View All Answers
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT-SWITCH BOARD,MLDB,ACB,BUSBAR,ETC,......?
What kind of maintenance is conducted for Transformer
What is VCB? where it is installed at SP. What is SP?
how ups works ? various parts of ups and working principle
Dear Respected sir how to test ABB REX521 protection relay by relay tester.
how to size H.T & L.T Panel ?
What is the Current equation in series RLC circuits.
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
Write down the name of 2 lady Bir Pratin of Bangladesh
For the requirement of a furnace of temperature range up to 1200 oC using silicon carbide rods, What is the required rate of transformer needed (please do it with all details)?
what is auto re-closer?
Zone of protection and tripping scheme of arc protection relay.
In aerodynamic turbines which element is NOT there a.stator b.compressor c. Fuel intake system d.fans
How to check 11000/1.732 to 110/1.732 Potentila transformer (PT)?
