Interested to Buy Any Domain ? << Click Here >> for more details...
In a Tap changing transformer where is the tap connected ,
is it connected in the primary side or it is connected in
secondary side
- 8 Answers
- 20634 Views
- Indiabulls, I also Faced
- E-Mail Answers
Answer Posted / ronak panchal
tap changer is connected at ht side.
its not depend on primary or secondary winding but where the
ht side and lt side is been defined.
if primary winding is ht and secondary winding is lt then
tap changer will be at primary.
| Is This Answer Correct ? | 18 Yes | 2 No |
Post New Answer View All Answers
What do you mean by ratio correction factor of instrument transformer?
What is the name of the winding to which supply is given?
we are having 110 Kv,250mA Electrostatic precipitators for coal fired boilers. what will be static voltage and current after discharge and what time it will remain before earthing?
Can I use star delta connected induction motor for dual supply voltage?
please give me solution to rectify the emi(electromagnetic interference)
WHAT IS THE DIFFERENCE BETWEEN AN ACB & mccb 7 WHAT IS THE CRITERIA WHEN TO USE WHICH OF THE TWO
CT Ratio of a energy meter connection is Red Phase : 100/5A, yello Phase : 50/5A & Blue phase : 100/5 A what is the overall Multiplication factor
What will happen to the protection and metering, if the polarity of a single or two PT/PTs in three phase system is reversed? Please provide reference if any.
State the points to be considered for selecting a particular type wiring.
How is the gain affected by the introduction of feedback in a control system.
what questions are asked in the interview for the post of an electrical maintenance engineer in FMCG companies?
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
What is the most accurate way of testing ELCB?ELCB is better than RCD?
How much earthing frequency is capable?
What is ideal IR values for ground and neutral.
