Interested to Buy Any Domain ? << Click Here >> for more details...
we have LPG spherical Tank and we want to install DP Xmtr
for level measurement.below are the physical measurements
Total height of tank is 1850 mtr but 0% level is 1000mm
above bottom and 100% level is 450 below upper side.What is
the LRV and URV and please mention the formula .The SG of
LPG is 0.53 and Wet Leg method will be used.
- 7 Answers
- 12213 Views
- I also Faced
- E-Mail Answers
Answer Posted / jabi
suppose the total height of tank is 18.5 mtr
LRV= 1mtr above from ground
URV= 14 mtr above from the ground(4.5mt below the top heigt)
Low pressure side total height= 13mtr
Differential pressure at LRV:
P(high)= height x SG
= 1 mtr x 0.53
= 530 mmWC
P (low)= 13 mtr x 0.53
= 6890 mmWC
LRV is equal to P(high)-P(low)
= 530-6890
= -6360 mmWC
Differential Pressure at URV:
P(high)= 14mtr x 0.53
= 7420 mmWC
P(low)= 13 mtr x 0.53
= 6890 mmWC
URV is equal to P(high)-P(low)
= 7420-6890
= 530 mmWC
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
What is difference between ESD and PLC please Explain me clearly.
if my flow is 20000 m3/h than which range of DPT i have to use????
What is difference between Ionization heat and bimetallic heat
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.
What is zero elevation and zero suppression?
HOW TO CALCULATE ACCURACY OF AN INSTRUMENT. WHICH IS COMPITABLE FOR USE.
what is the vital subject for scoring bhel exam&what is the question pattern
A valve in series with an orifice plate (DP transmitter), is aligned for constant pressure in the pipeline, if there is an error dx, How to align it in process.
how 3 out of 2 Logic/interlocks works? give brief explanation with help of diagram.
What is difference between differential pressure & delta pressure?
What is standard procedure of manual mapping in Radar type level transmitter?
how the arrangement of equipments done in control room
What is the principle of capacitance type level transmitter?
Why all the drains(Gland sealing,ESV,Casing inlet etc) are directly connected to the flash tank instead of hotwell of the condensor in the power plant? My Email Id:naba02222@gmail.com
In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?
