I have suguna 3 hp pump for my agreeculture work.It deliver
the water from 45 feet well .I suffered by powercut.During
powercut i got 2phase supply only .My question is can i
run the pump in 2 phase supply using capacitor?.Can u
explain me how to connect the capacitors?
Answer Posted / electrical alie
It is know form physics that you can provide water about 45
ft away. This is clear from the objective test that is run.
However when you try to sole this problem from the books
you have read, you find conflict. This is because if i
tried solve objective from the other book then i could not
solve this from the 3rd book. Therefore you must use the
motor curves that power the overload system to determine if
you unknown will operate properly. It will help if you can
determine what is standard height of an energy meter is
from ground.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
What are the parameters of water ( Water quality )to be monitored in Centralised HVAC ( water cooler chillers )
why would the rotor rotate at sub synchronous speed against the direction of rotating flux when d rotor of 3 phase IM is connected to 3 phase balanced supply and the stator windings are shortcircuited ??
How to know any size of cable if there are not written on cable? Answer must be theurical not by experience.
Why is the frequency not changed during transformation of electrical energy in a transformer?
Alternator rotor earth fault relay circuit
How to decide cable tray size?
What is the effect of atmospheric pressure & Temp; on efficiency of motor? Why NGR(Neutral Grounding Resistor) is used in 132/11 KV Transformer & how? What is the use of Auto T/F in Grid Station?
all details of DG UPS HVAC
What is voltage divider rule?
What is the meaning of HT Trivector Meter ?
temp of cast resin 1500kva tx formerwent up to 138.c but came down very fast to about 100.c within 20 mins when load was reduced from 70% to 60%
witch pump used in wtp
what is the use of permanent magnet generator in exciter
please send me the previous year's question papers of jindal GET exams
why the starting voltage drop in a cable needs to be limited?what is percentage of the voltage drop allowed during starting?