Interested to Buy Any Domain ? << Click Here >> for more details...
any calculation method for decide cable size for current?
- 1 Answers
- 5087 Views
- I also Faced
- E-Mail Answers
Answer Posted / gopal
i=v/R and R=rho.L/A . by analysing these fourmulas we find the size . here i is electric current in the conductor to flow or load current to flow . v is the voltage across the conductor , R is the resistance of the conductor . L is the length of the conductor ,rho is a constant of a material called specific resistance here the the material is the material of the conductor , A is the area of cross section of the conductor .
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is time response of the control system?
Air refrigeration cycle works on the
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
How to calculate the phase to phase clearness of HT /// LT bus bar?????
what should be the acceptrd value of winding resistance for 2.5MVA transformer
WITCH CARDS IN USE IN FIRE CONTROL PANEL.
how commomn gate triggering is given for TRIAC ? other thyristor wont be efffected?
Why control of DC motor is simpler?
why ht motors are star connected?
Is there any type of starter for DC motor other than two point,Three point and Four point starters?
Explain Even and Odd signals?
i ha done my 10th with 71% ,ITI with 81% 11th with 75% 12th 43% apprentiship with 71% in SAT i secure 1390 ,TOEFL 27 i was refused four times and in all me interview visa officar told that i am not Qualify for study in USA but i completed my 12th yes i got low persentage in my 12th but i seen to much student they already got visa with them 3 or 4 backlocs so why they are refused me ?
does buccholz in a transformer use batteries
how we can come to know that motor winding resistance which showing by DMM is right or wrong???is there any chart or something that we will compare & check???
give single line diagram of D.G distribution form alternator to main L.T panel?
