Interested to Buy Any Domain ? << Click Here >> for more details...
why cant we use mV instead of mA?
- 12 Answers
- 23998 Views
- ABB, Power Grid, Qatar Gas, USW, Visa Steel, I also Faced
- E-Mail Answers
Answer Posted / mohammed abbas
As length of the cable increses the line resistence also
increse, but the current remain same, suppose if your
using the long cable assume 50mtr the line resistance
assume 2 ohm for 50mtr, for 100mtr the line resistance will
be double 100=4 ohm. as per ohmns law. if you are measuring
the flow parameter for 50 mtr and another 100 mtr for same
process condition the reading will be diffrent, suppose if
your are using millivolt means but milli amps will remain
same.
the volatge will increse or decerse as the lenghth incerese
of decerses, but current remain same that is what milli
amps will be used
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
How to calibrate Magnetic flow Transmitter in Field
Senior engineer's please help me, what is Loop Checking and Loop test? and write difference also? soon urgent
What are the key features of a Distributed Control System? describing the various layers (sensor through to business system interfaces) as well as the hardware, software and security aspects of the DCS.
In VVVF DRIVES VOLTAGE IS ALSO VARY WITH THE FREQUENCY. HOW? WHAT IS THE DIRECT FORMULA RELATING THESE TWO.
plz you help about Que paper of mahagenco previous your,any model paper relad to it{maharastra power genration}
What is hp & mp seperator .& what is its working principle ?
Q-Explain the different load conditions that will produced different offset which may or may not be acceptable to thhe control function
Why even multiple power supplu r used in instrumentation system?
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
How to Calibrate Flow Switch in field
whatis range of marcury filled tempereture gague
installation process of orifice,a question asked for confusion creation in interview by BARC 1.if orifice is tightly fitted with pipe ,it will act like venturi 2.if orifice is left hanging in between liquid it will not create the pressure difference exactly,
what is controlling card in dcs? how u measure dcs memory?what is bus in dcs?how u know dcs speed n ehternet speed?
how can leve transmetter calibate in feild .and also put cv and flow plz .....
What is frequency factor in massflow meter? When using frequency output?
