What is the difference between a Junction Box and a
Marshalling Box?
- 8 Answers
- 126839 Views
- I also Faced
- E-Mail Answers
Answer Posted / manish panchal
JUNCTION BOX IS USED FOR TAPPING FOR CT AND PT SUPPLY IN
SWITCHYARD. IT ALSO USED IN CONTROL TERMINALS, IT ALSO USED
AS A JOINT.
MARSHALLING BOX IS USED IN OUTDOOR APPLICATION LIKE T/R
M.BOX USED WITH WTI AND OTI IT IS ALSO USED BIG M.BOX FOR
CT/ AND PT CONNECTION.
| Is This Answer Correct ? | 4 Yes | 19 No |
Post New Answer View All Answers
what is the major difference between LIBBP & HIBBP.. which one is most preferable..
what is meant by star/delta voltages as 440/220 in a 3 phase induction motor, and why it should be connected on STAR IN 3 PHASE SUPPLY
HOW CAN I GET 5CORE HO7 CABLE SIZE IF I HAVE 1800A?
Any Electrical Engineering jobs?Please refer for interviews. Thank you
A double circuit with dog conductor 66KV Transmission line from wind farm evacuation to feeding substation having capacity of 25MW for transmission. Can same transmission network be considered for further expansion of Power & how much in MW. If we need to expand next 10-15 MW more will there any augmentation is required in transmission network? Kindly reply asap.
What is the de rating factor of cable? What is the importance of the de rating factor in cable selection?
i have interview in Pepsi company what type of question will ask please send the question and answeer
how synchronous condenser is used in place of synchronous generator with out negotiating IEEE standards? Can i use 3 generators as synchronous generators and 2 generators as a synchronous condensers in an IEEE 14 bus system with out disturbing the standards?
redundant connection in contactor?
what are the assumptions made in swineburne's test?
why and how current drawn by battery charger depends upon the altitude where it is located?
What is the difference between acs 550 & acs 850
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
Difference between RCCB, RCBO and ELMCB.
What happens if the series current double?
