Interested to Buy Any Domain ? << Click Here >> for more details...
what is the function of breather in a transformer
- 29 Answers
- 115487 Views
- Areva, Bhel, RKM Powergen, Vijai Electricals, I also Faced
- E-Mail Answers
Answer Posted / gambheer singh indauliya
breather is used in transformer to absorb the moisture
contain from the air pass going inward of x mer.breather
reduce the problem of short circuit in transformer.breather
provide economic and efficient terms for controlling level
of moisture. in the breather a silica gel is used to absorb
dust particles from air & oil.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Why IR value of the (HT cable Plus synchronous motor) is less while individually having IR values in GΩ?
Can we convert off line transformer to on line transformer
why output is out of phase in case of common emitter?
How would you relate your key competencies to this position?
Write the analogous electrical elements in force voltage analogy for the elements of mechanical translational system.
hi, could someone help me to find a control design for syncronising panel .
in ring main system we use the isolater b/w transfer bus and main bus if we r not use isolatar than wat will be the effect in our sys.
what would happen if reactive power (kvar)is increased (more)or decreased (less)? how much exact reactive power should be maintained? and what should be done for that
Two bulbs of 100w and 40w respectively connected in series across a 230v supply which bulb will glow bright and why?
what questions will be asked for 11/33KV licence interview APSEB hyderabad. Can any one share question and answers.
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
When distance between two pulleys is not fixed, the tension of belt is adjusted by a) driver shaft b) driven shaft c) adjustment screw d) belt
what is the difference between gas group b and gas group c electrical equipment construction wise?
Please explain me about Relay curves and their sources to read ?
when we have to purchase the transformer by own i.e how much load will preferred HT connection?
