Interested to Buy Any Domain ? << Click Here >> for more details...
What happens if 25 Hz frequency is applied for 400/200,50 Hz
single phase Transformer.Will Voltage increase ?
- 2 Answers
- 11628 Views
- Bhel, Dawlance, IBM, I also Faced
- E-Mail Answers
Answer Posted / raji g
voltage will not increase obviously it will decrease because
the induced emf in the secondary winding the transformer is
directly proportional to the supply frequency.
Hence the voltage will reduce at the secondary winding
when will give the 25Hz.
But it is not advisable to give the 25Hz frequency to 50Hz
designed transformer.Because the transformer impedance
designed such that good efficiency at 50Hz only.
if u give the 25Hz the transformer winding may lead to get
over heat and may burn the windings due to the following reason
the reactacne(xl) of the transformer is direct proportional
to the supply frequency. so for reduced frequency the
impedance of winding will reduced and current will increased
to large level
| Is This Answer Correct ? | 16 Yes | 1 No |
Post New Answer View All Answers
11 kV line deraction check by an Engineer.
Consider three heater bank connected in 3 phase star with neutral.Each heater bank connected in each phase.So each phase get 230 volts supply.my question is,during balance condition, current flow in neutral or Not
What is the difference between electronic regulator and ordinary electrical rheostat regulator for fans?
What type of wiring series or parallel is used for conventional and addressable type FAS & why?
what will happen if earth of 33 kv cable (earthed system) is not connected to earthing pit?
how can maintain the power factor and why and this is how do work tell us
what is distribution board?
why do we carry out winding resistance test?
two way ckt diagram can be drawn by how many ways? give diagram
explanation of mesh bus bars
How to determine alternating current frequency?
How we can determine short circuiting current any plant and for example a plant which power generation is 415 volts and plant load is 500 kw.
how to electronic energy metter failed in electomagnectic fild passing in the metter and which thing to defect more on metter.
In the magnetic fluxes, what is the role of armature reaction?
if two transformers are placed parallel & both have fault impedance of 50KA will it increase or decrease show example?
