what is hysterisis loss and eddy current loss? how it occurs?
Answer Posted / jon
Hysteresis loss
is When the magnetic field through the core changes, the
magnetization of the core material changes by expansion and
contraction of the tiny magnetic domains it is composed of,
due to movement of the domain walls. This process causes
losses, because the domain walls get "snagged" on defects in
the crystal structure and then "snap" past them, dissipating
energy as heat. This is called hysteresis loss. It can be
seen in the graph of the B field versus the H field for the
material, which has the form of a closed loop. The amount of
energy lost in the material in one cycle of the applied
field is proportional to the area inside the hysteresis
loop. Hysteresis loss increases with higher frequencies as
more cycles are undergone per unit time.While the Eddy
current loss
The induction of eddy currents within the core causes a
resistive loss. The higher the resistance of the core
material the lower the loss. Lamination of the core material
can reduce eddy current loss, as can making the core of a
magnetic material nonconductive.
Is This Answer Correct ? | 6 Yes | 7 No |
Post New Answer View All Answers
How Can you do Maintenance of ACB of 2000Amperes
What is the rating of a circuit breaker needed for 300 kv load in 33KV supply line of 33/415 transformer ? Whether 800/1200 amp vaccum circuit breaker can perform for a 33 KV line in input in 415 volt in output of the transformer ?
what is tri state logic gate
what is meant by the phrase 'static load' in case of shorting in a generator excitation system?
In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?
why we are using earth pit in sub stations.?
Why we are using only Dyn11 tranformer in distribution system but not using a Dyn1 in distributing system?why not and advantage and disadvantage in both
why dc is used in control circuits for MV & LV switchgeras instead of ac
what is the use of current transformer in power transformer secondary side.?its connectyed in WTI
power transmission pole used one support , that only for support or earthing
what is the basic construction diffrance between servo motor ans sqiralcage induction motor
How to calculate Temp from Resister from PT100 equation,
How to calculate mf when meter equipment and meter are connected
why we cannot protect 100% winding of an alternator by using differential protection?
how the characterstics of control valve being done