Is a DC Transformer Possible? if Yes, Then Why, if not Then Why?
- 9 Answers
- 15720 Views
- I also Faced
- E-Mail Answers
Answer Posted / suresh kumar k
The question itself is a little wrong, infact the question
should be "Why we will not apply DC to a Transformer, if it
applies what happens?
The answer is, there is no inductance effect produced in DC
as such in AC. If we apply a DC voltage to the primary of
the winding then there will be no Back EMF produced in the
primary winding because of lack of self inductance in the
winding for DC. Hence huge currents of the order of
thosands of Amps flow in the Pri. winding and leads to fire
in the winding. Also Since there is no mutual inductance
effect in secondary of the winding there will be no induced
EMF in secondary.
| Is This Answer Correct ? | 9 Yes | 0 No |
Post New Answer View All Answers
What is the function of Governor in Hydro Power Station? What is the Function of Lightning Arrestor Voltage Transformer (LAVT)?
Explain about how is it working Earth fault'relay and wahts the resistance value of earth bed
What are the different circuits in thermal power plant?
What is the previous name of Cox's Bazar
sir, i'm preparing for hpcl exam officer trainee pls tell me how the exam ques paper pls pls
What is the use of oil in transformers?
What is the formula to calculate the rating of a three phase air circuit breaker
if we install two earth pits with a clear space of 5m without any interconnection,by checking the digital multimeter will it show continuity between earth pits? If so what would be the approx. value
1600 KVA ka transformer hi aghar lt side par 800A aur voltage 420 ho to HT side ki cable ki rating keya ho gi?
How does a transformer contribute towards the widespread popularity of ac system over dc?
Explain Need of a starter in a dc motor.? Also explain any two starting and speed control method of dc motor?
1.ZEBRA conductor(large size) 2.KUNDHA conductor( small size ) 3.panther conductor(very small ) 4.lepard conductor (very very small)
When calculating the speed of a rotor required for a particular frequency of synchronous generator we use the equation 60f/p Is this p is the number of pole pairs of rotor & do we consider the number of pole pairs in the stator is 1?
What is the importance of counter based plan & how is it scheduled?
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
