Interested to Buy Any Domain ? << Click Here >> for more details...
If we connect the capacitor banks for DG set for maintainig
the power factor, it will effect to alternator
windings??????????
- 7 Answers
- 12294 Views
- I also Faced
- E-Mail Answers
Answer Posted / mushtaq
Capacitors can be connected to DG set But, the Power factor should be always maintained below Unity (i.e lag), if it cross beyond the Unity (i.e lead) Alternator's Automatic voltage Regulator get burnt and simultaneously the windings
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
During FEED, you will have all the information with regards to cable. How will you calculate the MTO for MV and LV Cables? what are your considerations?
what is lrs tank water resistance.
How to select a contactor? How many types of contactors are available
prove that power consumed in 3 phase delta system is 3 times as compared to 3 phase star system
how we calculate the dick for a pole?
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
What Is Connection APFC Panel In Compony.
how we can calculate 2 phase welding transformer rating or total power?
how to interlock 3 incomer-ACB,1 buscoupler ACB,... pls answer this question and if possible send me the ckt diagram..haifriends2910@gmail.com
why Lightening Arrester Probe sharp at Top of telecom tower.
Post possible questions for Power Factor Panel FAT / SAT
what are the steps involved in generator load test?
Why it is possible to use PWM with a STATCOM and not with a conventional TCR based SVC
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
Why does the Solid state Rectifiers for 3-ph brake motors sometimes have 2 & sometimes 3 output terminals?
