Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / srinivasa chary
Thermal relay is used in DOL starter to protect the machine
from excessive current when it is over loded...esspecially
incase of low HP motors.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
What is difference is of VSD,VFD,VSDS, are they the same as the direct current to control dc using above mention
What is the tipical Online UPS input voltage for 20 KVA load ( 3 Phase or 1 Phase )? Why ? Explain it...?
why should the primary of transformer be connected in delta in a heat run test?
How isolater function when installed inelectrical 440V wiring
IF DISTANCE IS 100METERS B/W AMP.METER AND CURRENT TRANSFORMER WHAT WILL BE AFFECT IN ACCURACY .METER CAN SHOWING ACCURATE CURRENT OR NOT IF NOT WHAT CAN I DO TO GET 100% ACCURACY.
can a 150 kva 3 phase 440v/230V delta-wye step down transformer can be use as step up transfoermer with connected loads at 440v side?
1)What is a Triode? What are its uses? 2) What is a Triac? 3) What is a Thyristor?
Is there any standard guidelines/Criteria to design NGR/NGT.?
If short circuit ratio is high is it bad or good for a machine then tell the reason...
Why we are using Isolation Power Transformer inplace of commercial power transformer? What's the difference between them?
what is a bus riser in power system and why it is used
Differnce between negative Pahse SequenceFunction and unbalance Function?
I am having a 1500 KVA transformer whose secondary current is 2086A and my connected load is 1000 KVA, I am having 400 KVAR APFCR for PF improvement what ratio of CT should i install in LT EB Bus to get optimum PF improvement?
difference between Ac and Dc mcb ????
How much no load current of synchronous motor
