2.5mva transformer is installed in our company with oltc
but it is not working in auto mode ,it is operative in
manual mode control wiring is done how can i rectify it?
- 5 Answers
- 5739 Views
- Imdaad, I also Faced
- E-Mail Answers
Answer Posted / s. venkateswararao
check the selector switch auto mode comand, and auto tap
changer time setting lower and upper voltage level setings
to be checked.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what is the difference between fault current ant short circuit current?
what is package substation.how many types they have
What are IP protections used for electrical panels, JB, equipments installed in explosive zones like Petrochemicals, Oil & gas
can anyone explain the star-delta motor control wiring ,which wire go where and how they operate?
What is core CT & it's function?
draw a circuit diagram connecting transformer OLTC- RTCC- VCB-Marshalling Box otherwise Explain in words
What is q factor?
how to find the resistance and gap volatage of the diode??
reason of diode failure in alternator
if i am in front of transmission line how to know that current direction without any equipment
mccb service sittings be done?
DIFFERENCE BETWEEN NORMAL TRAFO AND THRISTER TRAFO?
15hp motor wound by 0.9mm & 0.95mm magnet wire. at no load test it draw 4.2A current. Another motor with same condition draw 9.2A current. How can that occur? pls help
bsec exam syllabus (mis)
What is the permissable nutral current of three phase system as per IS standards?
