Interested to Buy Any Domain ? << Click Here >> for more details...
why the generating voltage in India is 11kV or why is it be
transmitted as multiples of 11
- 34 Answers
- 125069 Views
- ACC, Bhel, ECI Engineering and Construction, NTPC, SBL, Senthur Power Services, I also Faced
- E-Mail Answers
Answer Posted / bhat rouf
because ,insulation,losses has the matter it,.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
What is the significance of integral controller and derivative controller in a pid controller?
HOW TO CHECK THE VECTOR GROUP OF A TRANSFORMER YD11?
In which of the following case, the rotating magnetic field is reversed? A regenerative breaking B plugging C dynamic breaking D forward motoring
what the Microsoft .NET framework is?
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
The moisture in air will condense at
Why do power lines not short out when they fall into water?
we have two motors 1250kW,6.6kV to be coupled on the same shaft ,so please provide assistance for their synchronisation.
Why we are use dol starter up to 10 hp
I want formula to calculate cable size as per load given in length & amp. I searched many sites but didn't right answer. Please reply me asap.
i had aplied Hindustan Petroleum corporation limited for the post of maintenance technician -Electrical,i want model questions,if anybody have please send it or please advice?
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
How is the gain affected by the introduction of feedback in a control system.
I want to design a heating coil of 80/20 nicrome for 3.5KW please give me the calculations choosing for physical dimensions assume coil voltage will be 110V AC assume necessary conditions
What is the efficiency during maximum power transfer?
