Interested to Buy Any Domain ? << Click Here >> for more details...
why we set -10 volt in vibration sensor output,why not +10
volt
- 3 Answers
- 24606 Views
- Sabic, TVS, I also Faced
- E-Mail Answers
Answer Posted / r.murugan
Vibration sensor output based on your probe gap
normal refrence from shaft and probe gap +1.2mm
corrosponding +1.2mm gap you will get output of the
proximitor -10v
if gap is increase voltage will increase gap is decrease
voltage will decrease
bently vibration probe calibration there is kit TK3-2E
PROXIMITOR POWER SUPPLY VOLTAGE -24V DC (THIS ONE PNP
FUNCTION BASE)
| Is This Answer Correct ? | 15 Yes | 2 No |
Post New Answer View All Answers
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
What is the purpose of LO Overhead tank in turbines.
Can combine control system for Emergency control system (ESD)and Fire & Gas System ( F & G) is possble to built and offer to client? Can such system is as per Norms in India?
Draw a wheatstone bridge circuit showing supply, meter and 3 wire RTD connection
What is the advantage of using locally fabricated hook ups over Pre fabricated hook ups in process instrumentation?
What is furnace draft control?
what is the process to make control schematic ?
What is stripper & spilitter ? Diffrence in this.?
Programmable Logic control.
how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???
What is the use of temprature compensation?
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
KAlman filter code for two dimension?
In dcs panel we are using diff type of modules ?what is module ? what is the use of modules ?diff type of module?
what is the procedure of belt scale calibration?
