Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / jaswant rajawat
Bus earthing truck is use to earth bus bars of switchboard
at the time of maintenance of bus bars. For this we have to
remove incomer breaker panel and insert bus earthing truck
so that bus bars will remain earthed during maintenance.
Cable earthing truck is use to earth incoming cable or
outgoing feeder cable in switchboard during maintenance at
transformer end or motor terminal box.
| Is This Answer Correct ? | 39 Yes | 3 No |
Post New Answer View All Answers
what are the ''pitting rings''and how cn they be controlled in a series generator
in science exhibition how lamp can blink when you clap near the lamp ? thank you
What are the advantage of free wheeling diode in a full wave rectifier?
Explain thin film resistors and wire-wound resistors
Pleae send me last 5 years of Question book about RRB chennai.
How can we calculate strength of copper hich is supplying electric power to heater and in it hold the heater also and what r all types of forces which is acting on it...
what is the saturation point of crgo lamination.
A mass of 1200g is accelerated at 200 cm/s2by a force. The value of the force required is:(a) 2.4N(b) 2400N(c) 240 kN(d) 0.24N
how can we determine size of a cable by knowing the kw or current rating of a load?how can we calculate the resistance box of a slip ring motor?
how to CHECK CT AND PT AT THE FAULT OCCUR IN GENERATOR RELAY PANEL .
I have 440v power coming to facility,( not being used ) can I buy large generator, (gas) to sell power back to electrical co.
can u please mail me the syllabus for GET exam for damodar valley corporation?
Explain the construction of the conservator, operation and purpose, and draw the diagram of the conservator.
Hello everyone, somebody knows what is a "surplice power" ? The hole phrase is: "This rating is appropriate for a generator set paralleled with an infinite bus e.g. a national electrical supply network or grid where the generator set is run at 100% load, 24 hours a day, 365 days a year and any surplice power is exported into the grid" Thanks in advance.
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
