What do you mean by Transformer?
Answer Posted / subrata
Transformer is a device, which works on the principal of mutual inductance and transfers electrical energy
from one voltage level to other voltage level (as desirable)
without change in frequency.
It works with a.c. only.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
different aspects of voltage stability
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
why moisture formation found in XLPE Armoured cable outer sheath
How to confirm the Phase shifting Transformer VECTOR GROUP relation , as below ZNy11.45d10.45-ZNYy0.15d11.15
what is the generator rating for 40 amp load of 3phase motor.?? 400v voltage of generator... plz tell me with formula its urgent...plzzz... and also tell me that this 40 amp at all phases mean 40 amp on red,40 amp on yellow,40 amp on blue...... or the total sum of that 3phase is 40 amp....
can anybody send me syllabus of rrb section engg (electrical). and also send previous question pepar...
What is the unit audit? if our Max demand is something and we found much more unit then how to improve our max demand?
How would your past experience translate into success in this job?
How to select cable the size, what is the parameters use and what is the formulas use for this cable size calculation?
0.5,1,1.5,2.5,4.0.6.0,10,16 square mm electrical wires how much take maximum current in 50htz
How to calculate that clean water supply in one Day from 150 KLD STP?
How to improve fuel cell in a distribution system?
How can I model an open-delta ground transformer for a network supplied by 4 unit GTG and power transformer in ETAP?
sugest any typical project ?
how brushed dc motor operating ?