Interested to Buy Any Domain ? << Click Here >> for more details...
IN star -delta motors normally first operated in star
mode {absulated given (r-y-b) phases after one miute change
in delta mode in this case i am change phase sequience for
example R -PHASE TO CHANGE Y-PHASE ;Y-PHASE TO CHANGE
R-PHASE SO THIS TIME MOTOR WILL HAPPEN RUNNIG MODE
EIGHTER(OR) STOP MODE(TRIP MODE)
- 6 Answers
- 8797 Views
- MacLellan, I also Faced
- E-Mail Answers
Answer Posted / asif.k64@hotmail.com
The motor will run in opposite direction.
| Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
what is the use of piston rings in the engine used for a generator...........
I have 2 KW electric water heater.I am gonna use it in controlling water temp.so I needed to increase or decrease the heating capacity.is there any electrical-electronic circuit for varying the resistance & so current?
why can we use cosine wave instead of sine in ac supply as both have same rms vale and ripple factor
How to Calculate the Fault Level of Electrical Installation
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
in control panel, how can i measuring the distance between one bus bar to another bus bar. then now only for bus bar. in mpcb and contactor also. that means one mpcb to another mpcb how much distance? how can i calculate that.
ACCORDING TO IEC WHAT SHOULD BE THE MINIMUM HEIGHT OF G.I. STRUCTURE OF CT, PT, ISOLATOR, LA?
in shunt clippers why a resistor is used in sereis with the input
What is the rotor frequency of 10 Hp 1440 RPM 50HZ 415V ?
what is the saturation point of crgo lamination.
What is the function of the generator exciter?
Whats the minimum value for I.R. that can be allowed for HT & LT alternators for operation?
HOW TO CALLICULATE RESITENCE,REACTANCE AND IMPEDENCE VOLTGE OF TRANSFORMER 13.33 KVA 144/240 VOLTS 93/56 A WITH FORMULA
What is an order of a system.
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
