Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / anonymous
p is the pressure of a specific point or column in a liquid
h is the height of the liquid column
d is the density of the liquid and
g is the acceleration due to gravity of that place
| Is This Answer Correct ? | 36 Yes | 11 No |
Post New Answer View All Answers
Can anybody please let me know Orifice plate sizing calculation formula and step by step procedure
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Why even multiple power supplu r used in instrumentation system?
in differential pressure transmitter,min&max pressure range for hp&lp
How the sizing of the analog signal cable is calculate?
Why are the uses 24vdc in industries
in sulfur process what is material of impulse line we use to connect with transmitter ? and does teflon affected by sulfur?
I have got a call of IOCL interview for projects having 2yrs experience. What sort of questions should I expect in the interview?
Meaning of the following a. IOP- Manimum; b. IOP- Maximu,;
WHY THE DEGREE OF VALVE PLUG AND VALVE SEAT IS SLIGTLY DIFFERENT I CONTROL VALVE TRIM DESIGN
please tel me the calibration of pneumatic controler.
Why boiler chimney area oxyden sensor fixing?
Can anyone convert a 5/2 way or 3/2 way valve into an ISO valve?
What is instrumentation measurement?
What are different type of instrument cable
