Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / prakash
according to Faraday law of electromagnetic induction emf is
produce when a conductor cuts the magnetic field.
But hear due to the rotation of magnetic field the pole is
not constant so we get the emf pulse ie ac
example- we get ac 50hz ac by 50pair of pole changes per second.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is electrical cable termination
how to calulate short circuit current for the following: 1.cable connecting 11KV of 22KV/11KV transformer to 11Kv of 11KV/415V transformer 2.what cable size should i use.
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
The power supplied to a 50mH inductor from a 120V, 60Hz source will be
how can we change the polarity of Alternating current rapidly? how frequency of ac can be controlled and changed easily?
how to select the automotive wire size by mathematical calculation. for xenon headlamp with ballast. the ballast given data voltage 10-17v,current permenant 6amp, run up phase is 15amp, peak at swicth on max 400micro sec is 40amp.the sum of cable resistance is 150mohm.please provide referenc document if any for relating the peak at switch on current,time & wire wire size
how to decide choke rating for drive?
why servomotor motor? where i apply for best output?
I have a drawing of a wound rotor induction motor for a crane. This crane motor has 5 forward speeds & 5 reverse speed implemented of course with different amount of resistance for each speed setting selected. What has got me scratching around is the fact that 8 of the 10 speed selections switch in uneven (unbalanced) amounts of resistances on each of the 3 connections to the motor's rotor.Can this be possible? I would have assumed this would produce unbalanced rotor currents and therefore vibration in the motor. I would greatly appreciate anyone's comments on this. Many thanks, Confused.
Define non-touching loop.
how to calculate power consumption in slip ring motor at different step
What is the difference IN MCCB's between thermal magnetic and electronic tripping system ?
What is meant by control system?
We have 250 KW x 2 motors, which are load from 25% to 100% varying load in every minute , so how can we compansate the power factor. pl give your opinions on the above subject.
how slip power recovery system work
