Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ati
its a ht breaker used to make and disconnect HT lines above
3.3kV; with extra protections
| Is This Answer Correct ? | 15 Yes | 10 No |
Post New Answer View All Answers
how we can calculate 2 phase welding transformer rating or total power?
What are the causes of having an rmu explode after installation? And how do u treat the bushings of an rmu?
how do i commission a distribution transformer knowing all its ratings and transformation ratios?d
A commercial Building is designed with 14th floor levels with indoor substation of three phase transformer with rated capacity of 1000 Kva.The transformer delivered 65% of its rated capacity at 0.67 power factor lagging.Because of low power factor, the power customer was penalized and certain cost was charged accordingly based on every point percentage lower than 85%.This situation may repeatedly happen on the succeding energy bills of power customer.The power customer is desired to improve its historical power factor of 0.67 lagging and no further penalty be impose by the local power company on the next bill. Q: Identify the appropriate solution you want to offer to Client?.Justify SCIENTIFICALLY and MATHEMATICALLY the principles behind the solution.
what is the difference between fault current ant short circuit current?
Show Details FROM:Muhammed Ikram TO:qa@allinterview.com Message flagged Saturday, June 4, 2011 10:07 PMMessage bodyHello all, i want to ask a question to all of you that what is VMM (voltage monitoring module )? how it work,s? i heard somewhere that it compare 1 phase voltage to other phase voltage. but there is also some setting on it. how to set it,s setting. please tell me briefly. Thank,s and Regard,s. Muhammed Ikram.
if 2 coil of 1000W connect in series and 200 v is applied across it . then what is the total power of coil when coil have only resistive load .
I want single line diagram for AMF & DG syncronizing panel
what will be project cost for 100 kv transformer connection under oyt scheme.
How Load Factor, Demand Factor, Diversity Factor etc best applied in designing an electrical circuit? Is it allowed to consider these factors in each and every panel in an electrical distribution system? Can any body suggest a good book for reference?
what is acceptance test in electrical engineering.
what is the principle of operation of CFL ??
What is CVT and what is relation with wave trap?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
If I want to buy a new Xformer for my plant what are the main parameter will I need to check?
