in transmiters(rose mount) how to check output 4-20ma ? and
input 24v? i need exact explanation?
Answer Posted / anwar mydeen
In rosemount transmitter, open the back side cover which
contains termination.
To check input Power:
switch on the multimeter and select the DC voltage
measurement and connect the positive(red) lead to positive(+
indication in the transmitter) and negative (Black) lead in
the negative terminal(-). then the reading shows 24V DC.
To Check 4-20ma output:
Switch on the multimeter and change the red lead to MA
section and remove one wire from the transmitter and connect
as series. it will show how much reading.
Is This Answer Correct ? | 6 Yes | 2 No |
Post New Answer View All Answers
what is a vortex flow meter,mass flow meter and electromagnetic flow meter.particular use of this.means in which condition particular meter is used.
please can any one tell me clearly about pid tuning i am confusing about this .how to tune pid easly?
What denotes the 5/8mm in the 3300XL 5/8mm proximitor probe?
hello can yoy pls send me previous papers of jindalpower and steel ltd.....'m from instrumentation..... mani1048@gmail.com
Identification of control valve parts.
describe flow nozzel principle?
How the sizing of the analog signal cable is calculate?
I have a Control VAlve having size of 2 ".Only the known parameter is Pressure drop . Its 2 Kg. Then How to calculate control valve sizing means Cv.
how to commission furnace ( water heater)
What is limitation of the ht.of the displacer of a level trol?
Describe how to use megger to measure the earth resistance and insulation resistance
why direct mounted pressure transmitters is always installed with DBB ( double bleed block) valve in process line or top of the tanks ?
What is hp & mp seperator .& what is its working principle ?
How a conductivity sensor & analyzer work at boiler, whats the principle & science is beyond this,How conductivity sensor sence & convert signal & move toward analyzer & analyzer show reading in percent? also what is temperature compensate option in conductivity analyzer
Please can anybody help for control valve sizing step by step procedure?