the max. power will be transferred if ……
a) sending end vol. is high b) receiving end v is high
c)…….. d) corona loss is least
Answer Posted / gms
@ 1st answer-dude itts a fill in da blanks
ans-power transmitted sacross a line is given by
P=(Vs)(Vr)sin(delta)/X
Vs=sending end volt
Vr=recieving end volt
delta=rotor angle of alternator
X=inductance of line
so power transferred is high if Vs,Vr,delta are high
and inductance is low
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what is metering cum synchronizing panel and how it is used?
WHY EARTHING NOT NEEDED IN BATTERY IN SUBSTATION
EXPLAIN METOD OF IMAGE OF TRANSMISSION LINE/ WHAT ARE ITS PRACTICAL APPLICATION?
What does the kvar means?
Can you explain about Restricited earth fault protection scheme
what is the effect of higher value of GD???
How to measure current and voltage in an ELV circuit
What is Phase margin?
Why there are some equipment(i.e:TV) that using 2-pin plug instead of three? What happen if there is current leakage? Are we going to get electric shock??
How many sprinklers should be in one pipe line?
What is step signal?
how many joint can done in HT line and what is life of the joint
How to design the earth grid for lightning protection in an industry
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
what is v/f control in VFD?