Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / hidayath
earthing is an safety process of protecting electrical
equipment from the unbalanced load, fault current or any
other abnormal condition occur on the any part of the
circuit. the neutral has been connected to the earth that
means the unwanted current is drawn in to the grount
without any damage.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What difference between ref protection and differential protection ?
What do you understand by oldham's coupling ?
what is mean by kneepoint voltage? when it will happen? ( my doubt is, if CT secondary is open means ct get saturation or blas? what are factors are required for calculations? plz give currect anws:
What is the formula to calculate the rating of a three phase air circuit breaker
What is the Good Earth resistance value of G.I & Cu. Chemical Earthing & Normal Pipe Earthing?
1. Design a counter which counts 0, 4, 8, 2, 6, and repeats using: 1.a using JK flip flops 1.b using T flip flops 1.c using D flip flops
1.dg on load alarm/stop alarm... 2.dg on load. piu alarm alarm kaise chek krte hai
Please tell me the formulaes while designing a substation for power Calculations in designing a 33 KV Substation?????
Draw a SLD of DG distribution up to main LT panel?
what is earth pit , how we can measured it, what earth rods reference
Define open loop control system.
how to calculate single phase motor efficiency ?
What is the Surge for 1.1 Phase Induction Motor(For Eg.1Hp) 2.3 Phase Induction Motor(For Eg.1Hp) 3.AirConditioner(For Eg 1Ton) 4.Refrigerator(For Eg 180Ltr or 160kW) 5.Induction Cooker 4. Ceiling Fan
Where I can get the sample question for post of Junior engineer electrical-II For RRB Bhubaneswar.
Its possible to use 3core 2R of 240 sq.mm cable for 3phases & separely 50sq.mm 3core cable fully for Neutral for connection of PCC to MCC 3ph..4wire system?
