Interested to Buy Any Domain ? << Click Here >> for more details...
what is the basic difference between capacitor and condenser ?
- 17 Answers
- 54917 Views
- ABB, Essar, I also Faced
- E-Mail Answers
Answer Posted / abhishek gupta
all the ans r wrong.........
| Is This Answer Correct ? | 9 Yes | 5 No |
Post New Answer View All Answers
What is the best thing to protect the motor from running over full current. CT or O/L or pressure transducer at the given pressure rating
how many joints are allowed in underground HT cable of 1 KM
Why insulation level follows this order? transformer < bus bar < circuit breaker & Isolator < transmission line.
How much load can take a 16 mm aluminum cable 3 phase
what about GD square and its important for motor design?
Different types of relay fault which phase sequence??
How many wall/floor flange will i use in bus duct system if we have in our design a 35th floor building.
11kv/433v delta/star distribution transformer primary side full load Ht current is 83.33A in , but input side VCB rating 800A.why?
What is meant by celling voltage & current in excitor ?
What is the power requirement of tamil nadu for one month?
Consider three heater bank connected in 3 phase star with neutral.Each heater bank connected in each phase.So each phase get 230 volts supply.my question is,during balance condition, current flow in neutral or Not
what is the meaning of WYE and DELTA in Electric meter?
I am experienced with house and industrial wiring but I don't have any licence how can I apply an licence and which type of licence i can get i didn't complete deee just only experience
Two liquids hot and cold in two vessels are there and an metal bar acts as a conductor of heat between the two vessels. what happens then. what happens after 24 hrs?
which type of stability limit is higher,steady state or transient? why?
