if u give d.c. supply to transformer primary then what happen.&why??????????????
Answer Posted / harish
In DC there will not be any rate of change of flux.. so transforming action will not take place
Is This Answer Correct ? | 20 Yes | 0 No |
Post New Answer View All Answers
When we connect the large capacitor bank in series ?
what happen ehen synchronisation is done at below rated speed
hi guys please tell me the procedure for mesuring the coil resistance of 3ph induction motor?
what is fault level of power system ?
how oil in the MOCB was reduced compared with OCB? what are the features of the MOCB?
How much should be the load percentage for 15kva Inverter and Iinut & I output load with Calculations
How does a digital electronic meter work??????
solar inverters was not connected to the nuteral link .this nutwral possible to any other systems
What is an Air COmpressor
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
In cable sizing calculation (determining the max route length of cable) why we choose the shortest length between cable length of full load current Iflc & starting current Istart?
what do you mean by class PS CT and what are technical details needed for calculating it?
What is touch potential and step potential?
what is cathodic protection and why it use in industries?
How to calculate of maximum demand if given 628kw, 785kva, 0.8 p.f.