Interested to Buy Any Domain ? << Click Here >> for more details...
if u give d.c. supply to transformer primary then what happen.&why??????????????
- 4 Answers
- 9556 Views
- DCS, DRDO, HCL, I also Faced
- E-Mail Answers
Answer Posted / aab.bharti
winding becomes burn because resistance of winding is very low &frequency of d.c is 0 hz so indutance is 0 result net impedence is very very low
| Is This Answer Correct ? | 12 Yes | 5 No |
Post New Answer View All Answers
WHY THREE PHESE SYSTEM VOLTAGE APPLIED IN 440 VOLT
why can the rotor of 3 phase slip ring induction motor not be a 2 phase rotor?
What are merits & De-merits of State-Space Method? What is series programming, parallel programming, general programming & direct programming ? And, difference between these programmings Techniques ?
What is corkscrew rule?
how to enter inverter parameter? without manaual?
Explain in brief description about the operation of DG sets.
what is acceptance test in electrical engineering.
How to calculate Number of Earthing Pits....???
how can i find cable size from current rating?
What is the cut-off rate?
Why do we perform an open-circuit test and short-circuit test on the transformer?
What are the difference between normal application Transformer and Solar application Transformer?
any application of back emf
what is the write prosidure of stringing of 8meter pcc pole.
Why does the radius of armature is less than the radius of pole shoe?
