Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / vineet kumar
Its not necessary that a power plant uses only two
rectifiers, it depends on the load present at the site and
the capacity of the rectifier or SMPS. Suppose the load at
the site is 120 Amps and the SMPS capacity is 2000W or the
current capacity of the recifier is 50 Amps. In that case 3
or more rectifiers is preffered. Rectifiers is used to
balance the load in each phase.
| Is This Answer Correct ? | 12 Yes | 6 No |
Post New Answer View All Answers
what are the components has to be done in fpga board (altera)?
Define virtual grounding?
Explain why an ammeter should be of very low resistance?
Explain the difference between masking and non-masking?
What are the dc,ac characteristics of op-amp?
Explain why normally control terminal of 555 timer is connected to ground through a 0.01µf bypass capacitor?
Why does mode in arm in cpsr have 5 bits instead it can have only 3 bits to define all the 7 modes?
Plz tell me the GATE interview question asked for ECE branch?
what is thermal tracking
what are the difference between dcs & plc & scada?
what is limitation of auto transformer?
What is firing angle?
Define what is meant by voltage regulation of a dc power supply?
I am studing Diploma Electronics from International Council for Management Studies-CHENNAI. Is it useful for getting engineering job within india or international ?
What is working principle of profibus?
